DeLonghi ECAM26455 manual Displayed Messages, Possible Cause, Remedy, Replace Filter, Press CLEAN

DISPLAYED MESSAGES

DISPLAYED MESSAGE	POSSIBLE CAUSE		REMEDY
FILL TANK	*OTVóDJFOU XBUFS JO UIF UBOL		Fill the tank with water and/or insert it correctly, pushing it
			as far as it will go until it clicks into place.
EMPTY GROUNDS CONTAINER	The grounds container (A22) is full.		Empty the grounds container and drip tray, clean and replace
			(fig. 26).
			Important: when removing the drip tray, the grounds contai-
			ner must be emptied, even if it is not completely full.
			If this is not done, when you make the next coffees, the
			grounds container may fill up more than expected and clog
			the machine.
GROUND TOO FINE ADJUST	The grinding is too fine and the coffee is delivered too slowly		Repeat coffee delivery and turn the grinding adjustment
MILL	or not at all.		dial (fig. 12) one click clockwise towards “7”while the coffee
			mill is in operation.
alternating with...
			If after making at least 2 coffees delivery is still too slow,
Insert water spout and press			repeat the correction procedure, turning the grinding
OK			adjustment dial another click (see the section “adjusting the
			coffee mill”on page 12).
INSERT GROUNDS CONTAINER	After cleaning, the grounds container has not been repla-		Remove the drip tray and insert the grounds container.
	ced
ADD PRE-GROUNDCOFFEE	The “pre-ground coffee”function has been selected without		Place pre-ground coffee in the funnel (fig. 17) or deselect
	placing any pre-ground coffee in the funnel.		the “pre-ground”function.
DESCALE!	The machine must be descaled.		The descaling procedure described in the "descaling" section
			(page 17) needs to be performed as soon as possible.
LESS COFFEE	Too much coffee	has been used.	Select a milder taste by pressing the	button (fig.
			9) or reduce the quantity of pre-ground coffee, if using the
			pre-ground function.
FILL BEANS CONTAINER	The coffee beans	have run out.	Fll the beans container (fig. 13).
	The pre-ground coffee funnel is clogged.		Clear the funnel with the help of a brush as described in the
			section “Cleaning the pre-ground coffee funnel”.
INSERT INFUSER ASSEMBLY	The infuser has not been replaced after cleaning.		Insert the infuser as described in the section “cleaning the
			infuser”.
INSERT TANK	The tank is not correctly in place.		Insert the tank correctly and press as far as it will go.
GENERAL ALARM	The inside of the appliance is very dirty.		Clean the inside of the appliance thoroughly, as described in
			the section “cleaning and maintenance”.
			If the message is still displayed after cleaning, contact
			De’Longhi Customer Experience.
EMPTY CIRCUIT FILL CIRCUIT	The water circuit is empty		Connect the water spout (D3) (fig.6) and press OK to deliver
alternating with			water from it, until it flows out normally.
Hot water press OK
REPLACE FILTER	The water filter is exhausted.		Replace the filter or remove it as described in the section
			“Water filter”.
Press CLEAN	Milk has been delivered recently and the tubes inside the		Press the CLEAN button (fig. 23) and keep it pressed until the
	milk container must be cleaned.		progress bar which appears on the display together with the
			message “Cleaning underway “ is complete.
INSERT WATER SPOUT	The hot water spout is not inserted or is inserted incorrect-		Insert water spout (D3) as far as it will go.
	ly.
INSERT MILK CONTAINER	The milk container is not inserted correctly.		Insert the milk container as far as it will go (fig. 21).

20