DISPLAYED MESSAGES
DISPLAYED MESSAGE | POSSIBLE CAUSE | SOLUTION |
|
|
|
|
|
FILL TANK | Insufficient water in the tank. | Fill the tank with water and/or insert it cor- | |
|
| rectly, pushing it as far as it will go until it | |
|
| clicks into place. |
|
|
|
|
|
EMPTY GROUNDS CONTAINER | The grounds container (A10) is full. | Empty the grounds container and drip tray, | |
|
| clean and replace (fig. 30). Important: when | |
|
| removing the drip tray, the grounds container | |
|
| MUST be emptied, even if it contains few groun- | |
|
| ds. If this is not done, when you make the next | |
|
| coffees, the grounds container may fill up more | |
|
| than expected and clog the machine. If the pro- | |
|
| blem persists, make sure the water tank is fully | |
|
| inserted, press the | button and deliver a |
|
| little water from the spout. | |
|
|
|
|
GROUND TOO FINE ADJUST | The grinding is too fine and the coffee is delive- | Repeat coffee delivery and turn the grinding | |
MILL | red too slowly or not at all. | adjustment dial (fig. 14) one click clockwise to- | |
|
| wards “7” while the coffee mill is in operation. | |
|
| If after making at least 2 coffees delivery is | |
|
| still too slow, repeat the correction procedure, | |
|
| turning the grinding adjustment dial another | |
|
| click until delivery is correct (see the section: | |
|
| “Adjusting the coffee mill” on page 12). | |
|
|
|
|
INSERT GROUNDS CONTAINER | After cleaning, the grounds container has not | Remove the drip tray and insert the grounds | |
| been replaced. | container. |
|
|
|
|
|
ADD | With the | Place | |
| ground coffee has not been poured into the | lect the | |
| funnel. |
|
|
|
|
|
|
DESCALE | The machine must be descaled. | The descaling procedure described in the section | |
|
| “Descaling” needs to be performed as soon as | |
|
| possible (page 18). |
|
|
|
|
|
LESS COFFEE | Too much coffee has been used. | Select a milder taste by pressing the | |
|
| button (fig. 11) or reduce the quantity of pre- | |
|
| ground coffee. |
|
|
|
|
|
FILL BEANS CONTAINER | The coffee beans have run out. | Fill the beans container (fig. 15). | |
|
|
|
|
| The | Empty the funnel with the help of a brush as | |
|
| described in the section “Cleaning the pre- | |
|
| ground coffee funnel” (page 18). | |
|
|
|
|
INSERT INFUSER ASSEMBLY | The infuser has not been replaced after | Insert the infuser as described in the para- | |
| cleaning. | graph “Cleaning the infuser” (page 17). | |
|
|
|
|
INSERT TANK | The tank is not correctly in place. | Ensure that the water tank is fully inserted. | |
|
|
|
|
21