EUROCHEF - PRO WALL HOOD
STEP 7: TIGHTEN - HANGING SCREWS
•With Filter Frame still removed from Step 2
•Adjust hood up to eliminate any gaps at ceiling. Tighten hanging screws.
•Add (2) more security screws + Washers at wood bracket.
•IMPORTANT: If Installing optional Backsplash Kit install this kit BEFORE installing wall anchors
(see instruction with kit)
Install Bottom Wall Anchors
•Drill 1//8" pilot holes into the two lower mounting holes. Enlarge the holes if they did not enter studs to 3/8".
•Install (2) or (3) wall anchors at bottom of hood.
•Remove anchor screws and add a flat washer provided. Drive screws into anchors and tighten.
•If a Wood Stud was discovered at wall anchor locations use 80mm Wood Screw supplied with Washer (instead of Wall anchor). Drive screws and tighten.
STEP 8: RE-INSTALL THE FILTER FRAME
•Use screws removed in Step 2 to
| 13 | |
|
