9 PREPARING ESPRESSO/COFFEE USING GROUND COFFEE (INSTEAD OF BEANS)
•Press the 
button (fig. 16) to select the ground coffee function. This disables the coffee mill function. The appliance displays
READY PRE-GROUND
•Lift the central lid, place one level measure of ground coffee in the funnel (see fig. 17) and proceed as described in section 6. Note: You can make just one coffee
at a time by pressing the | , | or | button once only. |
NOTE 1: Never add the ground coffee when the appliance is off to avoid it being dispersed inside the appli- ance.
NOTE 2: Never add more than one level measured scoop, otherwise either the appli- ance will not make the coffee, the ground coffee will be lost inside the appliance, dirty- ing it, or the coffee will run off in drips and the message "GROUND TOO FINE ADJUST MILL AND INSERT WATER SPOUT AND PRESS OK" will be displayed.
NOTE 3: When measuring the quantity of coffee to be added, use the measuring scoop supplied only.
NOTE 4: Use ground coffee for espresso coffee makers only. Do not use coffee beans,
NOTE 5: If the funnel blocks due to moisture inside the appliance or if more than one measure of
• Once the coffee has been delivered, to go back to making coffee using beans, deactivate the ground cof-
fee function by pressing the 
button again (the light goes off and the coffee mill is enabled for operation again).
10 PRODUCING HOT WATER
•Always make sure the appliance is ready.
•Make sure the water spout is attached to the nozzle (fig. 4);
•Position a container under the spout (fig. 3).
• Press the button (fig. 1). The appliance displays:
HOT WATER
and hot water is delivered from the water spout into the container below (you should not run off hot water
for more than two minutes at a time). To stop the flow, press the button. Once the set quantity of hot water has been reached, delivery stops automatically.
13
