Check that the two red buttons have snapped out, otherwise the door cannot be closed.
The two red buttons have | The two red buttons have not |
snapped out | snapped out |
CORRECTLY |
|
CORRECTINCORRECT
NOTE 1: If the infuser is not inserted correctly, until it clicks into place, and the two red buttons have not snapped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it, squeeze it to the right size by pressing it force- fully from the top and bottom simultaneously, as shown in figure 31.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the outlet then plug in again. Wait for all the lights to go off, then open the door and replace the infuser.
•replace the drip tray, complete with the grounds container;
•close the service door.
15.3Cleaning the milk container Proceed as follows:
• Remove the milk spout (fig. 32) and the milk intake tube.
• Remove the milk froth regulator by pulling it out- wards.
• Wash the container and lid in hot soapy water. Make sure there is no milk residue inside the two holes in the lid of the milk container indicated by the arrows in the figure or the milk intake tube.
• Replace the milk froth regulator, the milk intake tube and the milk spouts.
16 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the 
button, when the appliance is ready, you can use the internal menu to modify the fol- lowing parameters and functions:
• | Clock | • Length of time the appliance remains on | |
• | • | Water hardness | |
• | Descaling process | • | Factory default values |
• | Coffee temperature | • | Language |
17
