5751009900
Turning on and programming
the unit
ENGLISH
CONNECTING TO THE MAIN ELECTRIC SUPPLY AND TURNING THE UNIT ON
1.Before plugging the unit into the socket, check that:
• the main electric voltage corresponds to the value indicated on the rating plate on the back of the unit;
• the socket and power cord 10 are ade- quate for the voltage required;
•the socket is the right type for the plug, otherwise have the socket replaced;
•the socket is effectively grounded. Failure to observe this safety regulation absolves the manufacturer from all liability.
2. Before setting the required function, check that the timer switch 5 is on “ I “ (manual).
If you want to use the timer, turn the switch to the intermediate position 
.(timer on).
MANUALEI
12
1
9
0
6
STOPSTOP
TIMER: SETTING THE TIME
As with all clocks, the programmer/timer must be set to the right time. If it is 4:00 p.m., rotate the pointers clockwise (follow the direction of the arrow) until you reach 4:00 p.m.
Note: never rotate the timer dial in a counter- clockwise direction.
The timer is an electric clock and only works while the unit is connected to the outlet. When it is unplugged or there is no electricity, the timer stops (the clock is “slow”) and must be
TIMER: PROGRAMMING
1)Set the times when the unit will function by pushing the notches in the required inter- val towards the outside (each notch rep- resents 15 minutes).
2)Check that the timer indicates the exact time (see setting the time).
3)Choose the required function according to the instructions on the following page.
Period of operation
When the timer’s on the “0” (POWER OFF)
9
8
12
7
position, the appliance doesn’t work.
4
Example: from 7:00 p.m. to 9:00 p.m.
In this mode, the unit will repeat the set pro- gram every day.
Note: It is not necessary to modify the pro- gram to exclude “timer” operation. Just turn the switch to “ I “ (manual).
9
