TEMPORARY INSTALLATION
Note: In both cases (permanent and temporary installations) make sure that the Pinguino is positioned on level ground. If necessary use the two caster stops for the front casters
This installation makes it easy to | Suction discs may be used to |
use Pinguino in any room, | keep window or door closed (Fig. |
provided there is a window or a | 6). |
door: it allows you to use the |
|
Pinguino immediately (Fig. 5). |
|
Note: Additional exhaust hoses are available through Dè longhi America. For best results we do not recommend using more than one.
Pinguino is equipped with an adjustable window bracket. If you have a sash window, place the bracket on the window sill, extend the bracket fully within the window frame and lower the window onto the bracket. Insert the nozzle of the exhaust hose into the slot, then connect the hose to the air conditioner (Fig. 7).
Thanks to the wing nut, it’s possible to use the window bracket also for sliding windows. Position the hole of the
fig. 5 |
fig. 6 |
bracket so to allow a correct installation of the exhaust hose (see the following instructions).
window bracket
fig. 7
PREPARING THE UNIT FOR USE
1)Fit the exhaust tube in place; if your conditioner is supplied with a bayonet tube, it is fitted as illustrated in the diagram.
2)For permanent installation, place the appliance near the wall or window outlet. Make sure it is standing on a level surface and fit the special shock absorbers/castor stops underneath the castors.
1
2
1) Water collects at this point | 2) Bend this section |
| 3) Bend this section | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
fig. 8NOYESYES
ELECTRICAL CONNECTION
Check that the power supply voltage is 115 V ~ 60 Hz.
Important: if you need to use and extension cord, please be sure to use a heavy duty extension cord (minimum 14 gauge).
Before connecting the Pinguino to power supply, make sure that all switches on the front control panel are in the OFF position.
Connect power cord found in storage compartment at rear of the
Pinguino (Fig. 9).
fig. 9
8
