HOW TO START UP THE CONDITIONER
Plug the appliance into the wall socket.
The ON/OFF signal lamp (1) comes on and stays on for as long as the appliance is connected to the socket.
Select either Programmed or Non- programmed mode (see previous
Select the fan speed required pressing
“Fan speed” key D.
AIR-CONDITIONING
VENTILATION
Key C (Ventilation/
Conditioning) must be released Turn the thermostat to Max. cold.
Press key A (ON/OFF)
Signal lamp 5 (Conditioning) and either 6 or 7 (Min. or
Max. fan speed) will
come on.
Key C (Ventilation/ Conditioning) must
be pressed
The appliance comes on.
If not, refer to pag. 14.
To switch off the appliance, press key A
(ON/OFF main switch).
N.B: the “TIMER ON” signal lamp will only come on with “Programmed” mode.
N.B: For technical reasons, the temperature is not shown in degrees, but is represented by two lines which vary in thickness according to the temperature. It is advisable to begin by turning the thermostat to the maximum setting (thick green line = maximum cooling). When the room temperature is comfortable, turn the thermostat slowly away from the maximum heating or cooling position until the
This appliance is fitted with a special safety circuit. When the compressor switches off, this circuit prevents it from switching on again for at least 3 minutes.
11