TROUBLESHOOTING
Most malfunctions are caused by a very minor and easily solved problem. Before contacting your nearest authorized Service Center for assistance, consult the troubleshooting chart below.
SYMPTOMS
CAUSE | SOLUTION |
The Pinguino does not function:
The
-power failure
-the appliance is not plugged in
-the notches on TIMER dial have not been set
-switch is off
-the alarm warning light is on: the safety float has been enabled because the collecting tray inside the unit is too full
-thermostat has been activated
-exhaust hose to outside blocked
-fan blocked
-wait
-connect plug
-either push notches out or disable timer
-turn main switch on
-drain water using the drainage tube supplied, see page 5.
If problem persist, contact Service Center
-turn knob
-remove obstacle
-contact Service Center
The appliance switches |
|
| - switch off and contact Service | |
on and off constantly |
|
|
| Center |
The | - | window open | - | close window |
functions but the room is | - | source of heat in room | - | remove heat source |
not cooled |
| (heater, lamp, etc.) or room is |
|
|
|
| overcrowded |
|
|
| - | thermostat regulated too high | - | lower thermostat setting |
| - | air filter clogged | - | clean filter |
- the capacity of the conditioner is not adequate for the size of the room
14
