PREPARING FOR USE
The instructions below will enable you to prepare your air condi- tioner for operation as efficiently as possible.
Before use, make sure the air intake and outlet grilles are unob- structed.
Just a few simple steps and your comfort is ensured with your appliance:
•Fit the air exhaust hose (K) in the housing (G) at the back of the appliance (fig. 1).
•Fit the window outlet (N) to the end of the hose.
•Place the air conditioner near a window or French window.
•Adjust the length of the air exhaust hose to reach the window.
•Make sure the air exhaust hose is unobstructed.
•Open the window or French window slightly and position the window outlet (fig. 2).
•If you have a double window, use the suction pad (Q) provi- ded to hold the two parts of the window together (fig. 3).
For optimum results:
•If you have a sash window, place the window bracket (T) on the window sill, extend the window bracket fully within the window frame, fix the window bracket by using the locking pin then lower the window onto the window bracket. Insert the window outlet
(N)of the exhaust hose (K) into the slot, then connect the hose to the air conditioner (fig. 4).
•Thanks to the locking pins, it’s possible to use the window bracket also for sliding windows. Position the hole of the window bracket so to allow a correct installation of the exhaust hose (see figure 5).
•If the windows are large, use the window bracket extension
(U)to cover your window aperture, extending it to the requi- red length, then blocking it with the locking pins supplied (see figure 6). Make sure you do not cover the hole for the window outlet.
Keep the air hose as short and free of curves as possible to avoid bottlenecks.
6 |
3 |
2 |
1 |
5 |
12 
1
2 |
3 |
2 |
1 |
4 |
5 |
