USING THE REMOTE CONTROL
•Point the remote control at the receiver on the appliance. The remote control must be no more than 23 ft (7 meters) away from the appliance (without obstacles between the re- mote control and the receiver).
•The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat.
MAX. 23 ft (7 meters)
Inserting or replacing the batteries
•Remove the cover on the rear of the remote control (fig. 25);
•Insert two “AAA” 1.5V batteries in the correct position (see instructions inside the battery compartment);
•Replace the cover.
If the remote control unit is replaced or di- sposed of, the batteries must be removed and discarded in accordance with current legislation as they are harmful to the envi- ronment.
25
Setting the time
After inserting the batteries, the clock on the di- splay flashes until the time is set.
Proceed as follows. |
| |
• Press the | or | button until the correct |
time is reached.
Hold the button down to run rapidly through first the minutes, then the tens of minutes.
•Once the correct time has been reached, re-
lease the button and press the OK button to confirm.
•To cancel the settings programmed on the remote control and restore the original set-
tings, press the 
button lightly with the point of a pencil or pen.
USING THE REMOTE CONTROL UNIT
The first part of the controls on the remote con- trol are the same as those on the control panel of the appliance (fig. 26).
You should therefore refer to the instructions in the chapter Operating from the control panel to
•turn the appliance on or off and
•select the operating mode (air conditioning, dehumidifying, fan or Smart) and the fan speed.
•set the required temperature.
The following section describes the additional functions corresponding to the controls on the bottom part of the remote control.
26
12
