13
14 | 1 |
| 2 |
15 |
|
Replace the cap correctly and close the tank, pu- shing it in as far as it will go. The tank hole has a mesh filter to prevent the introduction of foreign matter. If necessary, this filter can be unscrewed and removed for cleaning under running water.
•The tank does not have to be full to use the water function, but the length of time the appliance will operate in water mode will be shorter.
•Do not fill above the level of the hole to avoid the water overflowing. The tank has no over- flow prevention system.
Replacing the limescale filter
Turn the appliance off and unplug it from the outlet.
Make sure there is no water in the appliance by emptying the tank and internal tray as described in the section: “End of season operations”.
Lay the appliance on its back as shown in figure
17.Rest it on a towel or piece of cardboard to avoid scratches or damage. Remove the filter co- ver by unscrewing the four screws (fig. 17).
Remove the filter delicately and loosen the two ties, making sure the two hoses connecting the filter do not slip inside the appliance. Fit the new filter (fig.19), following the same procedure in reverse (fig.
16
Water may leak out while replacing the limescale filter. You should therefore perform the operation in a suitable location.
After replacing the filter, wait at least an hour before starting the machine again.
When the filter has been replaced, turn the alarm off by pressing the
The appliance emits a beep.
8
