I n s t a l l i n g y o u r p o r t a b l e
a i r - c o n d i t i o n e r
• | Open the French window slightly and | |
| position the outlet 12 | as shown in figure C |
| and C1. |
|
• | Use the suction pads | 13 provided to hold |
| the two parts of the window together (fig. | |
| D and D1). |
|
4.17 inches (106 mm)
D |
| D1 |
|
|
|
SEMI-PERMANENT INSTALLATION
If required, the Pinguino can also be installed
in the window | in the | woo- | in the wall: you are | |||
pane | den | kick- | recommended to | |||
|
| board | of a | insulate | the | sec- |
|
| French | win- | tion of | wall | using |
|
| dow |
| suitable insulation. | ||
F |
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Keep the air hoses as short and free of curves as possible to avoid constrictions.
•Fit the flange accessory 10 provided in the hole
• Fit the hose 11 / 18 in the housing at the back of the appliance (fig. A / A1 page 5).
•Fit the end of the hose 11 / 18 to the flan- ge 10 as shown in fig. G.
.8 | inches | |
11 |
| cm |
| 30 |
11,8 inches | 11,8 inches | |
30 cm | ||
30 cm | ||
|
E
.8 | inches |
11 | cm |
30 |
E1
G
MAX 39.37 inches MAX100 cm
MIN 13.77 inches MIN 35 cm
Proceed as follows:
•Drill a hole in an outside wall or through a window pane.
Respect the height and dimensions of the hole given in figure F.
When the hose 11 / 18 is not fitted, the dril- led hole can be closed with the flange cap
10.
NOTE.
When installing the air conditioning unit semi- permanently, you should leave a door slightly open (as little as 1/2 inches (1 cm) ) to gua- rantee correct ventilation.
6