DeLonghi PACL90 specifications Operation, Boost Mode, Fan Mode With Air Filtration, Smart Mode

Operation

BOOST MODE

The BOOST mode is used to obtain rapid cooling. The fan is set to high speed and the tempera- ture is automatically set to 64°F (18°C). The boost light (D) on the control panel comes on and the

display will show .

FAN MODE WITH AIR FILTRATION

Adjust fan speed by pressing the SPEED button (R) as described for the air-conditioning mode. Remember that the higher the speed, the more air is filtered. If you select "Min" speed, less air is filtered but the appliance is also less noisy.

In this mode, Auto cannot be selected. The fan speed selected will be displayed.

SMART MODE

In SMART mode the air conditioner unit decides the best way to operate, to guarantee maximum comfort. In SMART mode the operating mode (air-conditioning or fan), the temperature and the

fan speed are automatically controlled and the display will show .

SETTING THE TIMER

The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by optimizing operating periods

How to program delayed start up

•Plug the appliance into a socket and press the ON/OFF (A) button, then select the required operating mode and other settings (temperature, fan speed, etc).

•Press the ON/OFF (A) button again to place the appliance in standby mode.

•Press the timer button (S). The two centre segments flash on the display.

•Use the “+” (H) o “-” (M) buttons to set the number of hours delay before the appliance comes on. The setting is increased or decreased by an hour at a time; however, when the buttons are held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait

a few seconds for the data to be acquired.

The indicator light (I) flashes until the appliance starts up.

You can set the appliance to come on with a delay of up to 24 hours.

To cancel the timer setting, press the timer button (S), and use the “-” button (M) to set the time to “00”. The indicator light (I) will stop flashing.

How to program delayed shut down

•Delayed shut down can be programmed in any operating mode.

•Press the timer button (S). The two centre segments flash on the display.

•Use the “+” (H) o “-” (M) button to set the number of hours delay before the appliance goes off.

The setting is increased or decreased by an hour at a time; however, when the buttons are held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait

a few seconds for the data to be acquired.

The indicator light (I) flashes until the appliance shuts down.

To cancel the timer setting, press the timer button (S), and use the “-” button (M) to set the time to zero. The indicator light (I) will stop flashing.

9