23.NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don't leave tool until it comes to a complete stop.
24.DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the influence of drugs, alcohol or any medication.
25.MAKE SURE TOOL IS DISCONNECTED FROM POWER SUPPLY while motor is being mounted, connected or reconnected.
26.THE DUST GENERATED by certain woods and wood products can be injurious to your health. Always operate machinery in well ventilated areas and provide for proper dust removal. Use wood dust collection systems whenever possible.
27.WARNING: SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIES contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from
•crystalline silica from bricks and cement and other·masonry products, and
• arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
ADDITIONAL SAFETY RULES
FOR DRILL PRESSES
1.DO NOT operate your drill press until it is completely assembled and installed according to the instructions.
2.IF YOU ARE NOT thoroughly familiar with the operation of drill presses, obtain advice from your supervisor, instructor or other qualified person.
3.YOUR DRILL PRESS MUST be securely fastened to a stand or workbench. If there is any tendency for the stand or workbench to move during operation, the stand or workbench MUST be fastened to the floor.
4.NEVER turn the drill press "on" before clearing the table of all objects (tools, scrap pieces, etc.).
5.NEVER start the drill press with the drill bit or cutting tool in contact with the workpiece.
6.USE ONLY drill bits, cutters, sanding drums and other accessories with 1/2 shank or less.
7.ALWAYS keep hands and fingers away from the drill bit or cutting tool.
8.DO NOT ATTEMPT to drill material that does not have a flat surface, unless a suitable support is used.
9.AVOID awkward hand positions where a sudden slip could cause a hand to move into the drill bit or cutting tool.
10.TO PREVENT ROTATION OF THE WORKPIECE, ALWAYS clamp work securely to table if it is too short to contact the column (see "OPERATION" section of this manual) or when using hole saw or cutting tools larger than
1/2 in diameter.
11.WHENEVER POSSIBLE use clamps or vise to keep workpiece from rotating with the drill bit or cutting tool.
12.USE recommended speed for drill, accessory or workpiece material.
13.MAKE CERTAIN all lock handles are tightened
before starting the machine.
14.NEVER perform layout, assembly or
15.BE SURE drill bit or cutting tool is not damaged and is properly locked in the chuck before operating.
16.MAKE SURE chuck key is removed from chuck before starting drill press. ONLY use chuck key provided with your drill press. It is equipped with a
17.ADJUST the table or depth stop to avoid drilling into the table.
18.ALWAYS stop the drill press before removing scrap pieces from the table.
19.WHEN drilling large workpieces, MAKE SURE the material is supported at table height.
20.SHUT OFF the power, remove the drill bit or cutting tool, and clean the table and work area before leaving the machine.
21.DON'T wear gloves, necktie, or loose clothing when operating the drill press.
22.SHOULD any part of your drill press be missing, damaged or fail in anyway, or any electrical component fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged or failed parts before resuming operation.
23.ADDITIONAL INFORMATION regarding the safe and proper operation of this product is available from the National Safety Council, 1121 Spring Lake Drive, Itasca, Illinois
SAVE THESE INSTRUCTIONS.
3
