Delta 14070 instruction manual

4.Insert raising rack (E) Fig. 5, which was removed in STEP 2, into groove in table bracket (H) making sure gear inside table bracket is engaged with teeth of raising rack.

Fig. 5

5.Slide raising rack (E) Fig. 6, and table (J) onto drill press column, as shown. Make sure bottom of raising rack (E) is engaged with flange (K) on base of column.

Fig. 6

6.Re-assemble ring (D) Fig. 7, which was removed in STEP 2 to column. IMPORTANT: Bottom of ring (D) MUST NOT be pushed all the way down onto top of raising rack

(E). MAKE SURE top of raising rack (E) is under bottom of ring (D) and that there is enough clearance to allow rack (E) to rotate around the column without binding. Then tighten set screw (L) BEING CAREFUL NOT TO OVERTIGHTEN.

Fig. 7