UNPACKING
Remove any protective materials and coatings from all of the parts and the tool. The protective coatings can be removed by spraying
If any parts are missing, do not attempt to plug in the power cord and turn ON" the machine. The machine should only be turned ON" after all the parts have been obtained and installed correctly.
ASSEMBLY
ATTACH SPARK SHIELD AND GRINDING SHIELD
Refer to Figure 1.
1. Fit two M5 x 10mm hex screws with a M5 lock washer and flat washer. Use assembled hex screws and washers to secure spark shield (A) to the wheel guard. Spark shield should be approximately 1/8" from the grinding wheel.
2.Repeat previous step for second spark shield.
3.Use one M6 x 16 mm carriage bolt, inserted through the outermost hole in the spark shield, to attach the grinding shield (B). Secure using one M6 flat washer and one lock washer and a threaded thumb knob.
4.Repeat previous step for second grinding shield.
FIGURE 1
ATTACH TOOL REST
Refer to Figure 2.
1.Remove the knob (D), star washer, and washer from the carriage bolt on the lower portion of wheel guard.
Using the carriage bolt, star washer, washer and fastening knob, attach the work rest bracket (A) to the inside of the wheel guard as shown.
2.Attach tool rest (B) to the tool rest support using one tool rest fasten knob.
3.Adjust the position of the tool rest support so that the tool rest is approximately 1/8" from the grinding wheel
(C).
4.Repeat above steps for second tool rest.
D
FIGURE 2
9
