FLEXIBLE LAMP
The flexible lamp operates independently of the grinder. To turn the lamp on and off, rotate switch (A) Fig. 13.
WARNING: To reduce the risk of fire, use 50 watt or less, 120 volt, reflector track type light bulb (not sup- plied). A standard household light bulb should not be used. The reflector track type light bulb should not extend below the lamp shade.
STARTING AND STOPPING GRINDER
The switch (A) Fig. 14, is located on the front of the grinder. To turn the grinder “ON” push the left hand por- tion of the switch, and to turn the grinder “OFF” push the right hand portion of the switch
A
Fig. 13
A
Fig. 14
GRINDING WHEELS
WARNING: THE USE OF ACCESSORIES AND ATTACHMENTS NOT RECOMMENDED BY DELTA MAY RESULT IN RISK OF INJURIES. Grinding wheels used with this grinder should be rated for 3600 RPM or higher and be 8" in diameter with a 1/2" arbor hole.
Two aluminum oxide grinding wheels are supplied with your grinder: one 36 grit and one 60 grit. For best grinding results, and to maintain good balance, always keep the wheels properly dressed. Do not force the work against a cold wheel. The grinding wheel should always be run at idle speed for one full minute before applying work. It is recom- mended that only balanced wheels be used with your grinder. The use of balanced wheels adds years to the life of the bearings on the grinder and by eliminating the most common source of vibration, more accurate work is accomplished.
DRESSING A
GRINDING WHEEL
When dressing a grinding wheel, use a suitable silicone carbide stick type dresser, as shown in Fig. 15. Bring the dresser forward on the tool rest until it just touches the high point on the face of the wheel and dress the wheel by moving the dresser back and forth. Repeat this oper- ation until the face of the grinding wheel is clean and the corners of the wheels are square.
SILICON CARBIDE
GRINDING
WHEEL
STICK
DRESSER
TOOLREST
Fig. 15
9
