ATTACHING STOCK STOP AND TABLE EXTENSIONS
1.Decide on which side of the saw table you want the stock stop (A) Fig. 8, and attach the stock stop (A) on the table extension (B).
2.Insert the ends of table extension (B) Fig. 9 into the two holes on the end of the saw base and into the two holes of retaining bracket (C). Tighten the screw (D) to hold the table extension in place.
3.Attach the left hand table extension (E) Fig. 10 in the same manner.
MOVING CUTTINGHEAD TO
THE UP POSITION
1.Push down on the switch handle, and pull out the cuttinghead lock knob (B) Fig. 11.
2.Move the cutting head to the up position (Fig. 12).
B
Fig. 11
A
B
Fig. 8
C
B
D
Fig. 9
E 
Fig. 10
Fig. 12
7
