STORAGE

A

C

B

Fig. 47

BLADE CHANGING WRENCH STORAGE

A

B

Fig. 48

You can store the blade changing wrench (A) Fig. 47 in the slot (B) behind the fence (C).

LOCKING CUTTINGHEAD IN THE DOWN POSITION

When transporting the saw, lock the cuttinghead in the down position. Lower the cuttinghead (A) Fig. 48 and push in cuttinghead lock knob (B) until it engages with the hole in the cuttinghead.

REAR SUPPORT/STABILIZER & CARRYING HANDLE

Use the rear support/stabilizer and carrying handle to carry the machine.

Carrying the machine by the switch handle will cause misalignment. Always lift and carry the machine by the base or by the carrying handle (C) Fig. 49.

Keep the rear support fully extended during all cutting operations. Push the rear support in only when storing the machine.

C

Fig. 49

MAINTENANCE

CHANGING THE BLADE

Use only cross-cutting blades.

Do not use carbide-tipped blades with deep gullets. They can deflect and contact the guard.

Use only 10diameter saw blades that are rated for 5200 RPM or higher and have 5/8diameter arbor holes.

Disconnect machine from power source.

17

Page 17
Image 17
Delta 36-585 Maintenance, Blade Changing Wrench Storage, Locking Cuttinghead in the Down Position, Changing the Blade