Delta 36-585 instruction manual Side Supports, General Cutting Operations

Holes are provided in the fence to attach an auxiliary fence. This auxiliary fence is constructed of straight wood approximately 1/2" thick by 3" high by 20" long.

Use the auxiliary fence (A) ONLY with the saw blade in the 0° bevel position (90° to the table). Remove the auxiliary fence before you make bevel cuts.

Fig. 31 Fig. 32

SIDE SUPPORTS

This machine has two side supports to help stabilize the machine, and to help support long or wide workpieces.

The supports are located on either side of the table. The machine comes with the supports in the saw (Fig. 31). To utilize the supports, pull them out to their full length (Fig. 32).

Fig. 33

Fig. 35

GENERAL CUTTING OPERATIONS

Fig. 34

Fig. 36

Your machine can cut:

1.standard 2 x 4’s lying flat or on edge at 45° right and left miter angles (Figs. 33 and 34).

2.standard 2 x 6’s in the 90° straight cut-off position in one pass (Fig. 35).

3.standard 4 x 4’s in one pass (Fig. 36).

4.crown molding and other bevel-type cuts (Fig. 37).

5.various sizes of plastic pipe (Fig. 38).

14