![](/images/new-backgrounds/1258960/25896011x1.webp)
FOR DELTA TABLE SAWS ONLY
9.Fasten the table adapter plate (B) to the right side of the saw table. Place a 7/16" lockwasher onto a 7/16- 20x1" hex head screw (D), insert screw through the table adapter plate and thread screw into right side of saw table. Repeat this process for the two remaining holes. NOTE: Before tightening screws (D), use a straight edge to make sure top of the adapter plate (B) is level with or slightly below surface of the saw table. Also make sure that the front edge of the adapter (B) does not stick out past the front edge of the saw table.
FOR TABLE SAWS OTHER THAN DELTA
9.Assemble table adapter plate (B) Fig. 12, to the right side of the saw table as shown using three 3/4 inch screws, lockwashers and hex nuts (not supplied). IMPORTANT: If the
(E) on the saw table and make certain the top of adapter plate is level with or slightly below the surface of the saw table. Also, make certain front of adapter plate (B) Fig. 12, does not extend out past the front edge of the saw table.
FOR ALL TABLE SAWS
10.Assemble the table (A) to the three brackets (B) Fig. 13, using three #8x7/8" screws (I), (E), and (F), Fig. 14. NOTE: Screw (I) Fig. 9, must be removed in order to attach the left side table bracket to the table.
NOTE: The two screws (E) and (F), Fig. 14, can be tightened and screw (I) Fig. 14, should be left slightly loose at this time.
11.Assemble the two brackets (J) to the rear table support
(K) using the two
D
B
Fig. 12
Fig. 13
E
IF
Fig. 14
| M | J | L | |
K | L | |||
|
Fig. 15
6