UNPACKING AND CLEANING
Your new scroll saw and stand is shipped complete in one container. Carefully unpack the saw, stand and all loose items from the shipping container. Figure 2 illustrates the saw and all loose items and Figure 3 illustrates the stand and all related parts. Remove the protective coating from the saw table surface. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the table surface with a good quality paste wax. Buff out the wax thoroughly to prevent it from rubbing into
your workpieces.
14
13
12
|
| 1 | 11 |
|
| 10 | |
|
|
| |
|
|
| 9 |
2 | 5 |
| 18 |
|
| ||
|
|
| |
3 |
|
| 7 |
4 |
|
| 6 |
Fig. 2
1 - Scroll Saw
2 - Holddown Foot
3 - 1/2" Long Hex Socket Head Screw - for fastening holddown foot to rod
4 - Lockwasher - for fastening holddown foot to rod
5 - Flat Washer - for fastening holddown foot to rod
6 - Table Insert
7 - 5mm Wrench
8 -
9 - Flat Washers - for fastening front of saw to stand (4)
10 - Lockwashers - for fastening front of saw to stand (2)
11 - Hex Nuts - for fastening front of saw to stand (2)
12 - 5/8" Long Hex Head Screws - for fasten- ing rear of saw to stand (2)
13 - Lockwashers - for fastening rear of saw to stand (2)
14 - Flat washers - for fastening rear of saw to stand (2)
5
