FASTENING SCROLL SAW
TO STAND
1.Place scroll saw on top braces of stand and fasten front of saw to top front brace using the two
2.Fasten the rear of the saw to the stand using the two
5/8" long screws (F) Fig. 6, and lock washers
(G). The 5/8" long screws (F) are also shown in Fig. 7, and are threaded up into the threaded holes located on bottom of saw base.
A
BC
D E
A
B
Fig. 5
G
F
Fig. 6
F
F
3.Figure 8 illustrates the saw (H) fastened to the stand (J). Place the stand on a level sur- face and securely tighten all stand mounting hardware.
Fig. 7
H
J
Fig. 8
7
