ASSEMBLING FENCE
TO SHAPER TABLE
1.The fence on this shaper can be mounted parallel to the miter gage slot using two holes (B) Fig. 14, or
90degrees to the miter slot by using two holes (A). The following illustrates mounting the fence parallel to the miter gage.
2.Place fence body (C) Fig. 15, on the table as shown, and locate the two fence locking levers with washers (D) and fence lock bars (E).
C
D
E
Fig. 15
3.Fasten bar (E) to the front of the fence half using the locking lever and washers (D), as shown in Figs. 16 and
17.Assemble the remaining bar to the other fence half in the same manner. NOTE: Locking levers (D) are spring- loaded and can be repositioned by pulling out the handle and repositioning it on the nut located underneath the hub of the handle.
4.Locate the two fence locking handles and washers, one of which is shown at (F) Fig. 18, and fasten fence body (C) to one of the set of holes located on the shaper table illustrated in Fig. 14.
9
A
B
A
B
Fig. 14
E
D
Fig. 16
E
D
Fig. 17
C
F
Fig. 18