Delta 46-765X, 46-745, 46-746 instruction manual Lubrication

A

B

Fig. 75

A

B

Fig. 76

5.Use a Phillips screwdriver (A) Fig. 75 to remove the five cover screws (B) (three of which are shown). The other two screws are located under the power cords.

6.With a 5/16” Allen wrench (A) Fig 75, remove Allen screw (B) Fig. 76. NOTE: When re-assembling, make sure that the screw passes completely through the pivoting control bracket and into the headstock, allowing the headstock cover to pivot.

A

B

A

Fig. 77 Fig. 78

7.While holding the control panel (A) Fig. 77 with one hand, remove the cover (B) Fig. 77. To prevent the control panel

(A) from falling, loosely re-attach the Allen screw (B) Fig. 76 to the control panel.

8.Replace belt.

9.To assemble, reverse the procedure.

A

B

AB

Fig. 79 Fig. 77

LUBRICATION

Use a light oil to lubricate eccentric (A) Fig. 79, and pivot points (B) on both the headstock and the tailstock. (Tailstock illustrated).

Use the tip of a screwdriver (A) Fig. 80 to press on the opening, and drop light oil into the handwheel cover (B) of the tailstock.

22