Weslo WLTL29010 Maintenance And Trouble-Shooting, PROBLEM The power does not turn on, 31 j, View

MAINTENANCE AND TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppres- sor is plugged into a properly grounded outlet (see page 7). Use only a single-outlet surge sup- pressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge sup- pressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps. Important: The treadmill is not compatible with GFCl-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

C.Check the circuit breaker located on the treadmill

C

frame near the power cord. tf the switch protrudes

as shown, the circuit breaker has tripped. To reset TrippedReset the circuit breaker, wait for five minutes and then

press the switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Check the batteries in the console. If the batteries need to be replaced, see "BATTERY INSTALLATION" on page 8. Most problems are the result of drained batteries.

b. Remove the screws from	the hood, and carefully
remove the hood. Locate	the Reed Switch (89) and
the Magnet (88) on the left side of the Pulley (75).

F

1/8"_ -_ _---

Turn the Pulley until the Magnet is aligned with the

Reed Switch. Make sure that there is a gap of

89--

--75

about 1/8" between the Magnet and the Reed
Switch. If necessary, loosen the Screw (31) and
move the Reed Switch slightly. Retighten	the Screw.
Re-attach the hood, and run the treadmill	for a few
minutes to check for a correct speed reading.

31 j	--	"88
Top	IIIO1=
View

12