Delta 50-851 instruction manual

5.Place ten-hole rubber gasket (J) Fig. 8, on blower flange (H). Align holes in gasket with mounting holes in blower flange and press gasket onto flange as shown.

J

H

Fig. 8

K

J

A

6.Align mounting holes in chute (K) Fig. 9, with holes in gasket (J), which was assembled in STEP 5. Place a 5/16" lockwasher onto a 5/16-18x5/8" hex head screw, insert screw through the chute and gasket, thread the screw into the motor assembly, and tighten securely. Repeat this process for the 9 remaining holes.

Fig. 9

K

A

Fig. 10

7.Apply a bead of silicone sealant around flange of chute (K) Fig. 11. Align holes in eight-hole gasket (M) Fig. 11, with mounting holes in chute (K) and press gasket into place as shown.

K

M

Fig. 11

6