R
Fig. 11
11.Place the drill press head on column, as shown. Line up head with base and tighten two head locking screws
(R) Fig. 11.
12.Thread the three pinion wheel handles (Z) Fig. 12, into the three threaded holes in the pinion shaft, as shown.
13.Make certain the tapered hole in the bottom of the spindle (T) Fig. 13, and the taper on the spindle adapter
(U) are clean and push the spindle adapter (U) up into the spindle, making certain the tang (V) engages and locks with the mating slot inside the spindle.
14.Make certain the bottom taper of the spindle adapter (U) Fig. 14, and the tapered hole in the chuck
(W) are clean and push the chuck up onto the spindle adapter (U) as far as it will go. NOTE: Household oven cleaner can effectively remove any substance from the spindle and chuck; however, carefully follow the manu- facturer’s safety rules concerning its use.
15.Open the chuck jaws as wide as possible by turning the chuck sleeve (X) Fig. 15.
16.Place a block of wood (Y) Fig. 15, on the drill press table and lower the spindle until the chuck contacts the piece of wood. Exert pressure to properly seat the chuck.
CHUCK KEY
This drill press is provided with a
Z
Fig. 12
T
V
U
Fig. 13
U
W
Fig. 14
X
Y
Fig. 15
9
