STARTING
Prior to starting, refer to your engine manual for proper starting procedure.
1.In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to Engine Owners Manual for correct procedure.
2.Check engine oil level. See Engine Owners Manual for correct procedure. NOTE: There will
be a slight amount of oil in the engine from factory testing.
8. | Start engine. See Engine |
| Owners Manual for correct |
| procedure. NOTE: When engine |
| rope is pulled, pressure starts |
| building in the gun. If the engine |
| does not start after two pulls, |
| pull the gun trigger to relieve this |
| pressure. |
9. | Depress trigger on gun to |
| start water flow. NOTE: Stand |
| on a stable surface and grip |
| gun/spray wand firmly with both |
| hands. Expect the gun to kick |
| when triggered. |
10. | Release trigger to stop water |
| flow. |
11. | Adjust spray for the task being |
| performed by changing quick |
3.Verify the filter screen is in water inlet of pump.
NOTE: Cone side faces out.
4.Connect
Filter Screen
connect nozzle. See How To Use |
Spray Wand instructions in this |
section. |
SHUTTING DOWN
1. After each use, if you have |
applied chemicals, place chemical |
hose into container of clean water |
and draw clean water through |
water source to pump inlet. NOTE: Water source must provide a minimum of 5 gallons per minute at 20 PSI.
5.Connect high pressure hose to pump outlet.
High
Pressure
Hose
Water
Source
6.If applying a chemical or cleaning solution, see How To Apply Chemicals/Cleaning Solvents instructions in this section.
7.Turn water source on. NOTE: Failure to do so could
cause damage to the pump.
| chemical injection system to rinse |
| system thoroughly. NOTE: Failure |
| to do so could cause damage to |
| the pump. |
2. | Turn engine off. See Engine |
| Owner’s Manual. NOTE: NEVER |
| turn the water off with the engine |
| running. |
3. | Turn water source off. |
4. | Pull trigger on spray gun to |
| relieve any water pressure in |
| hose or spray gun. |
5. | See Storage section in this manual |
| for proper storage procedures. |
A09741 | 12- ENG |
