ATTACHING THE SANDING DISC
1. | Clean the sanding disc plate (A) Fig. 8. |
|
| A |
2. | Peel the backing from sanding disc and press the |
|
|
|
| disc (B) firmly into position all the way around the |
|
|
|
| B |
|
| |
| sanding plate (Fig. 8). |
|
|
|
|
|
|
|
Fig. 8
ATTACHING THE LOWER COVER FOR THE SANDING DISC
B
Install the lower cover (A) Fig. 9 on the belt and pulley |
|
guard, using the three M4 x .7 x 12mm sheet metal |
|
screws (B). | A |
|
Fig. 9
INSTALLING THE DISC SANDER TABLE
1.Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 10 partially into the hole in the base of the sander. Insert the rod (B) into the hole. Align the flat of the rod (B) with the screw (A). Tighten the screw (A).
2.Slide the table assembly (C) Fig. 11 on the rod (B).
3.Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 11 into the hole in the table support bracket. Align the flat on the rod (B) with the screw (A). Tighten the screw (A).
|
|
|
| Fig. 11 |
| F |
A |
| B |
| |||
|
|
|
| |||
|
|
|
|
|
|
|
E
C 
B
Fig. 10 |
| A |
|
|
|
To avoid trapping the work or fingers between the table and the sanding disc, the table edge (E) Fig. 11 should be positioned a maximum of 1/16" away from the sanding disc (F). Loosen the screw (A) and adjust the table accordingly.
11
