Delta Essential Guidance for TS200 and TS200LS Saws: Setup and Alignment

NOTE: Before tightening the wing nut (M) Fig. 15, make certain a gap of at least 1/8" is between the bottom edge of the splitter (N) and the top surface of the table (P) and that the protrusions (K) are inside the slot of the splitter assembly (H).

8.Use a straight edge to see if the splitter (H) Fig. 16 is aligned with the saw blade (R). If an adjustment is necessary, the splitter (H) can be moved left or right and rotated.

9.When the splitter is properly aligned with the saw blade, tighten the screws (C) and (G) Fig. 17.

R

H

Fig. 16

P

H

N MK

Fig. 15

G

C

Fig. 17

MITER GAUGE

The miter gauge is shipped assembled and is supplied with a T-slot bar (A) Fig. 18 that is inserted into either one of the two T-slotted miter gauge grooves (B) located in the table top. The T-slot prevents the miter gauge from falling when it is extended beyond the front of the table when cross-cutting extra wide workpieces.

A

B

Fig. 18

ATTACHING MITER GAUGE HOLDER

DISCONNECT MACHINE FROM POWER SOURCE.

E

A

F

B

G

Fig. 19 Fig. 20

13