Delta Electronics CME-DN01 instruction sheet

2007-10-12

5011642701-DNT1

DeviceNet Communication Module (CME-DN01) Instruction Sheet

‹DeviceNet is a trademark of the Open DeviceNet Vendor Association, Inc.

‹Please thoroughly read and understand the following contents to ensure correct use before operation.

‹The content of this instruction sheet may be revised without prior notice. Please consult our distributors or download the most updated version at http://www.delta.com.tw/industrialautomation

A.Panel Appearance and Dimensions

		3	4	5
[2.35]59.7			125K 250K
	[0.57]14.3		500K		[2.26]57.3	1
			NETM OD SP
		ADD1 ADD2 BAUD
				CME-DN01
			2
			72.2 [2.84]		35.8 [1.41]	3.5 [0.14]

UNIT: mm(inch)

1.For RS-485 connection to VFD-E

2.Communication port for connecting DeviceNet network

3.Address selector

4.Baud rate selector

5.Three LED status indicators for monitor

B. Wiring and Settings

Refer to following diagram for details.

MAC address Date Rate

				1: Reserved
125K 250K				2: EV
500K				3: GND
NETMOD SP
				4: SG-
ADD1 ADD2 BAUD
	CME-DN01			5: SG+
				6: Reserved
				7: Reserved
				8: Reserved
	V+	CAN-H	Empty CAN-L V-
			pin
Setting baud rate		Setting MAC addresses:
0			use decimal system.
BAUD
Switch	Baud
Value	Rate		ADD1	ADD2
0	125K
1	250K
2	500K
Other	NOT
	used

C.Mounting Method

Step1 and step2 show how to mount this communication module onto VFD-E. The dimension in the following is for your reference.

Dimensions

	UNIT: mm(inch)
STEP 1	STEP 2

D.Power Supply

No external power is needed. Power is supplied via RS-485 port that is connected to VFD-E. An 8 pins RJ-45 cable, which is packed together with this communication module, is used to connect the RS-485 port between VFD-E and this communication module for power. This communication module will perform the function once it is connected. Refer to the following paragraph for LED indications.

E.LEDs Display

1.SP: Green LED means in normal condition, Red LED means abnormal condition.

2.Module: Green blinking LED means no I/O data transmission, Green steady LED means I/O data transmission OK. Red LED blinking or steady LED means module communication is abnormal.

3.Network: Green LED means DeviceNet communication is normal, Red LED means abnormal.

NOTE

Please download the auto EDS generator and user manual at http://www.delta.com.tw/industrialautomation/