Demco AC20037 manual John Deere 8000 Track Mounting Brackets and Skid

JOHN DEERE 8000 TRACK MOUNTING BRACKETS AND SKID

REF. PART		QTY.	DESCRIPTION
NO. NO.
1.	12315-35	1	Right Baseplate for Sidequest
2.	12316-35	1	Left Baseplate for Sidequest
3.	02851	8	3/4”-10UNC x 8.50 Hex Head Bolt (Gr. 5)
4.	02961	8	3/4”-10UNC Nylon Insert Lock Nut
5.	12317	12	20mm-2.5 x 250mm Hex Bolt
6.	12186-95	4	Top Pin 1.25 x 10.25
7.	02397	8	Lynch Pin
8.	12185-35	4	Extension Arm
9.	00085	24	1/2” Flat Washer
10.	01254	24	1/2”NC x 1.50 Hex Head Bolt (Gr. 5)
11.	02178	24	1/2”NC Nylon Insert Lock Nut
12.	35631	2	350gal. Skid Assembly (tank not shown)
-	35632	2	500gal. Skid Assembly (tank not shown)
			7	7
				6
			Tractor	4
			of	2
			Rear
			1	3

12
		11
		11
		10 9
		9 10
5		5	10 9
			10
	4	9
		8
		4
4		7	8
		7
		6

3 3

Use existing 6 washers

3 From removed track bolts

ofTractor Front

12

Installation John Deere 8000 Track

Use any three holes in a row of the five holes depending on the track width. When position is determined remove every other bolt of the six bolts in the track mount, that will match up with the three bolts (#5) in the bracket. Repeat for other side of track mounting. On the row of bolts to the front of the tractor, hold bolts in bracket up to just short of flush of the bottom of bracket, secure in that position with vice grips. Also adjust track so bolts will miss lugs. Then slide in place and tighten all bolts. See

diagram.

Page 18