SPRAYER CHECKLIST:
Downtime caused by field breakdowns is costly and time consuming. Many breakdowns can be eliminated by periodic equipment maintenance. By spending time reviewing this checklist before seasonal spraying application time and following proper after season care, you can save time and money later.
!WARNING: To Prevent Serious Injury Or Death
•Keep hands, feet, and loose clothing away from rotating parts.
•Wear protective clothing recommended by your chemical and fertilizer manufacturer when working with chemicals.
Check Before Going To The Field :
1.NOZZLES
Check tip for excessive wear by checking for grooves in or near tip opening. Check nozzle spacing by starting at center and working outwards. Check boom for proper height.
2.HOSES
Check all hoses for worn or soft spots. Be sure all hose clamps are tightened and hoses are not kinked or pinched. Check for leakage in any lines.
3.TANK
Remove and clean agitator orifices. Check orifices for excessive wear by checking for grooves in or near orifice opening. Inspect fitting and grommets to insure they are in good condition.
4.CONTROLS
Check for leakage, plugging, or wear on all valves, fittings, etc. Clean off any build up of foreign material.
5.PUMP
Check to be sure pump turns freely.
6.FRAME
Be sure all bolts are tightened.
7.REPLACEMENT PARTS
Replace all worn or damaged parts.
After Season Care:
NOTE: It is important to wear proper safety equipment when cleaning the SIDEQUEST . See your chemical or fertilizer package for this information.
1.After spraying chemicals, run water mixed with cleaners through tank, pump and all hose hookups. If wettable powder dries out in the system, it is very difficult to put back into suspension and can cause malfunction, damage or injury.
2.When cleaned, tank should have all openings closed or covered to keep dirt from entering.
3.Pump should be flushed with soluble oil and pump ports plugged to keep out moisture and air.
4.Disassemble tips and rinse with water or cleaning solution. (Appropriate for chemical sprayed).
5.Clean tip opening with a wooden toothpick. Never use wire or hard object that could distort opening.
6.Dispose of all unused chemicals or solutions in a proper and ecologically sound manner.
6.Water rinse and dry tips before storing.
NOTE: DETHMERS MANUFACTURING COMPANY does not and will not make any recommendations concerning application of various chemicals or solutions. These recommendations relate to either amount or procedure of materials applied. If you have any questions regarding application of certain chemicals or solutions, contact your chemical supplier and follow chemical manufacturer recommendations.
Page 31
