Demco Sprayer Truss Boom, Boom Carrier And Safety Stand Installation, Safety Stand Lock Assembly

TRUSS BOOM, BOOM CARRIER AND SAFETY STAND INSTALLATION

			20	21
				47
				47
		20	5
	41		45
	21		5
43	43		47
41
46			47
38
24	19			(DBFT)
23
		47		Boom
				Floatation

6

Mount

*FOR REFERENCE NUMBER LIST AND DESCRIPTION SEE PAGE 28

NOTE: Always lock the Safety Stand in the down position when unhitching the sprayer and lock it in the up position before towing the sprayer.

BOOM CARRIER ASSEMBLY INSTRUCTIONS

21.Bolt the Boom Mounting Brackets (#20) to the rear of the frame as shown using four 1/2" x 1-1/4" hex head bolts (#43) and nylon locknuts (#45).

NOTE: The Boom Mounting Brackets and Boom Mounting Tubes may be mounted using any set of two holes depending on boom height desired.

22.Bolt the Boom Mount Brace Angles (#21) to the frame and the Boom Mounting Brackets (#20) using four 1/2" x 1-1/4" hex head bolts (#43) and nylon locknuts (#45).

23.Bolt the Boom Mounting Tubes (#5) to the back of the boom mounting brackets using four 3/8" x 2-1/2" square U-bolts (#47) and nylon locknuts (#41).

24.Attach the DBFT to the Boom Mounting Tubes using four 3/8" x 2-1/2" square u-bolts (#47) and 3/8" nylon locknuts (#41) then bolt the Truss Boom Center Section onto the DBFT using six 1/2" x 1-1/4" hex head bolts (#43) and 1/2" nylon locknuts (#45).

SAFETY STAND ASSEMBLY INSTRUCTIONS

25.Insert safety stand (#6) through holder (#19) before mounting onto boom bracket.

26.Attach safety stand holder (#19) to boom mounting tubes using a 3/8" x 2-1/2" sq. u-bolt (#47) and nylon locknut.

38

46 24

23

19

SAFETY STAND LOCK ASSEMBLY

27.Install lock spring (#24) and 1/2" flatwasher (#46) into small tube on safety stand holder (#19) as shown.

28.Insert Lockpin (#23) through tube into spring and lock washer.

29.Place 5/32" x 1" cotter pin (#38) between flatwasher and wall of tube into lock pin.

Page 20