ENGLISH

NOTES:

•The on-screen display signals are not output from the color difference (component) video signal (MONITOR OUT) jacks.

•The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT jack during playback of a video component. For example, if the TV monitor is connected to both the AVR-3802’s S-Video and video monitor output jacks and signals are input to the AVR-3802 from a video source (VDP, etc.) connected to both the S-Video and video input jacks, the on-screen display signals are output with priority to the S- Video monitor output. If you wish to output the signals to the video monitor output jack, do not connect a cord to the S-VIDEO MONITOR OUT jack. (For details, see page 16.)

•The AVR-3802’s on-screen display function is designed for use with high resolution monitor TVs, so it may be difficult to read small characters on TVs with small screens or low resolutions.

•The setup menu is not displayed when “HEADPHONE ONLY” is selected.

•Speaker system layout Basic system layout

•The following is an example of the basic layout for a system consisting of eight speaker systems and a television monitor:

Subwoofer

Center speaker system

Surround back speaker systems

Before setting up the system

1

Check that all the connections are correct, then turn on the main unit’s power.

2

SETUP

Display the System Setup Menu.

 

Setting the power amplifier assignment

Make this setting to switch the power amplifier for the surround back channel to Multi.

1

TUNING

 

At the System Setup Menu, select “Power Amp

 

ENTER

Assignment” and press the ENTER button.

 

BAND

MODE

 

 

 

SHIFT

 

 

TUNING

 

 

Front speaker systems

2

TUNING

BAND

MODE

 

TUNING

Select “Surround Back” to use as the surround back channel, “Multi” to use as multi zone out.

When “Surround Back” is selected

When “Multi” is selected

Set these at the sides of the TV or

screen with their front surfaces as flush Surround speaker systems with the front of the screen as possible.

With the AVR-3802 it is also possible to use the surround speaker selector function to choose the best layout for a variety of sources and surround modes.

•Surround speaker selector function

This function makes it possible to achieve the optimum sound fields for different sources by switching between two systems of surround speakers (A and B).

A

A

A

A

B

SB

SB

B

B

SB

SB

B

SB: SURROUND BACK SPEAKER

 

 

 

 

 

 

Using A only

 

Using B only

 

 

3

ENTER

Enter the setting.

 

The System Setup Menu reappears.

SHIFT

 

Setting the type of speakers

•The composition of the signals output from the different channels and the frequency response are adjusted automatically according to the combination of speakers actually being used.

1

TUNING

At the System Setup Menu select “Speaker Configuration”.

 

BAND

MODE

 

TUNING

 

10