4 | Once “Meter” or “Feet” is selected in Step 3, |
the Delay Time screen appears automatically. |
5 | TUNING | Select the speaker to be set. |
| BAND | MODE |
| TUNING |
|
ENGLISH
Setting the channel level
•Use this setting to adjust so that the playback level between the different channels is equal.
•From the listening position, listen to the test tones produced from the speakers to adjust the level.
•The level can also be adjusted directly from the remote control unit. (For details, see page 27.)
•When using both surround speakers A and B, their playback levels can be adjusted separately.
1 | TUNING | At the System Setup Menu select “Channel Level”. |
|
| |
| BAND | MODE |
| TUNING |
|
6 | TUNING |
BAND | MODE |
| TUNING |
Set the distance between the center speaker and listening position.
The distance changes in units of 0.1 meters (1 foot) each time the button is pressed. Select the value closest to the measured distance.
Example: When the distance is set to 3.6 m for the center speaker
2 | ENTER | Switch to the Channel Level screen. |
| ||
SHIFT |
|
If “Yes” is selected for “Default”, the settings are automatically reset to the default values.
Please note that the difference of distance for every speaker should be 4.5 m (15 ft) or less. If you set an invalid distance, a CAUTION notice, such as screen right will appear. In this
3 | TUNING | Select “Test Tone Mode”. |
| BAND | MODE |
| TUNING |
|
case, please relocate the blinking speaker(s) so that its distance is no larger than the value shown in highlighted line.
7 | ENTER | Enter the setting. |
SHIFT | The System Setup Menu reappears. |
The
NOTES:
4 | TUNING |
BAND | MODE |
| TUNING |
Select the mode.
Select “Auto” or “Manual”.
• Auto:
Adjust the level while listening to the test tones produced automatically from the different speakers.
• Manual:
Select the speaker from which you want to produce the test tone to adjust the level.
Example: When the “Auto” mode is selected
•If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 9).
5 | TUNING |
|
|
| TUNING |
BAND | MODE |
|
| BAND | MODE |
| TUNING |
|
|
| TUNING |
Select “Surr. Sp.”, then select the surround speaker(s) from which you want to produce the test tone (A, B or A+B).
•Surr. Sp.: A
Adjusts the balance of the playback level between the channels when using surround speaker A.
•Surr. Sp.: B
Adjusts the balance of the playback level between the channels when using surround speaker B.
•Surr. Sp.: A+B
Adjusts the balance of the playback level between the channels when using surround speakers A and B at the same time.
The “Surr. Sp.” can only be selected when both surround speakers A and B have been selected at the “Speaker Configuration” (when both A and B have been set to “Large” or “Small”).
6 | TUNING | Select “Test Tone Start”. |
| BAND | MODE |
| TUNING |
|
13