

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifi cations

Presetting Radio Channels

(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.
1Press [SHIFT] to select the memory block (A to G).
2Press [CHANNEL + –] or [NUMBER (1 ~ 8)] to select
the desired preset channel.

Listening to Preset Channels

1Tune in the broadcast channel you want to preset.
2Press [MEMORY].
3Press [SHIFT] to select the block (A to G) in which the
station is to be preset.
4Press [CHANNEL + –] or [NUMBER (1 ~ 8)] to select
the preset number.
5Press [MEMORY] again to complete the setting.
The strength of both the XM satellite and terrestrial signals can be
checked at menu “Input Setup” – “Antenna Aiming” (vpage 39).

Checking the XM Signal Strength and

Radio ID

1Either turn <SOURCE SELECT> or press [SAT TU 1/2]
to select “XM”.
2Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3Adjust the position of the antenna until “SIGNAL:
GOOD” is shown on the display.
4Press <STATUS> until the channel you want to check
(example: “XM001”) is displayed.
5Press [TUNING] and select channel 0 (XM000).
The radio ID is shown on the display.
Radio ID
Operation on the Main Unit
Playback
<SOURCE SELECT>
<TUNING PRESET> <STATUS>
uiop
Press <TUNING PRESET>, then turn <SOURCE SELECT>
to select the preset channel.
Operation on the Remote control Unit.
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
[TUNING]
[SHIFT]
[CHANNEL + –]
uiop
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[SAT TU 1/2]
[TUNING]
[MEMORY]
[MODE]
[SAT TU 1/2]
[NUMBER]
uiop
[Front] [Rear]