Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifi cations
1Press CH SELECT/ENTER.
2Press ui or CH SELECT/ENTER to select “Fader”.
3Use o p to adjust the volume of the speakers.
(o: front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
Fader Function
This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1Press CH SELECT/ENTER.
Channel Volume
FL 0.0
dB
SR 0.0
dB
C 0.0
dB
SBR 0.0
dB
FR 0.0
dB
SBL 0.0
dB
SW 0.0
dB
SL 0.0
dB
Fader
FRONT : REAR
2Use ui or CH SELECT/ENTER to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3Use o p to adjust the volume.
b In the case of a subwoofer, reducing the volume when it is at “–12
dB” will change the setting to “OFF” (none).
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1Connect the HDMI to the AVR-989 with equipment
compatible with the HDMI control function (vpage
58).
2Put the power on for all the equipment connected to
the HDMI.
3Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Steps 1~3 do not have to be repeated once started.
b Carryout steps 2 and 3 should any of the equipment be plugged
out.
4Switch the television input to the HDMI connected to
the AVR-989.
5Switch the AVR-989 input to the HDMI input source
and check if the picture from the player is ok.
6Put the television power on standby and check if the
AVR-989 goes into standby.
If the AVR-989 does not work please check the following.
• Is the menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
(vpage 30) set to “ON”?
• Is the menu “Manual Setup” – “HDMI Setup” – “Power Off Control”
(vpage 30) set to “ON”?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step’s 2 and 3.
• Menu “Input Setup” – “Assign” – “HDMI In” (vpage 38) setting
has changed.
• There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
Operations
NOTE
When the input source is “iPod”, you cannot perform channel level
setting.
Playback
CH SELECT/ENTER
uiop
QUICK SELECT
<POWER>
<STANDARD> <DSP SIMULATION>
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
CH SELECT/
ENTER
uiop
QUICK SELECT
uiop
CH SELECT/
ENTER
[Front] [Rear]