

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifi cations
Multi-zone Operations

Turning the Power On and Off

GOperation on the main unitH
Press <ZONE2 ON/OFF>.
When the power turns on, the multi-zone indicator ( ) lights on
the display.
GOperation on the remote control unitH
In the zone mode you want to operate, press [ZONE2 ON] or [ZONE2
OFF].

Turning off the Sound Temporarily

q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [MUTING].
The sound is reduced to the level set at menu “Manual Setup”
– “ZONE2 Setup” – “Mute Level” (vpage 32).
To cancel, either adjust the volume or press [MUTING] again.
The setting is canceled when the zone’s power is turned off.
• The source selected for ZONE2 is also output from the recording
output connectors.
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2, playback is
only possible if the digital signal being input is in PCM (2-channel)
format.
NOTE
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 audio output connectors.

Adjusting the Volume

GOperation on the main unitH
q Press <ZONE2 / REC SELECT> and select the zone to be adjusted.
w Turn <VOLUME> to adjust.
GOperation on the remote control unitH
q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [VOLUME].
– – – –70dB ~ –40dB ~ +18dB[Variable range]

Selecting the Input Source

GOperation on the main unitH
q Press <ZONE2 / REC SELECT> and select the zone to be adjusted.
w Turn <SOURCE SELECT>.
GOperation on the remote control unitH
q Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2]
to “ZONE2”.
w Press [SOURCE SELECT].
• Also press [SOURCE SELECT] when in standby mode, the power
turns on.
• When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing [MAIN ON] or [MAIN OFF].
Multi-zone

<ZONE2 ON/OFF>

<VOLUME><SOURCE SELECT>

<ZONE2 / REC SELECT>

Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
• The volume can be increased up to the value set at menu “Manual
Setup” – “ZONE2 Setup” – “Volume Limit” (vpage 32).
• The ZONE2 volume can be adjusted only when “ZONE2” is selected
at menu “Manual Setup” – “Option Setup” – “Amp Assign”
(vpage 32).
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[SOURCE

SELECT]

[VOLUME]

[MUTING]

[ZONE2 ON]

[MAIN ON]

[MAIN OFF]

[SOURCE
SELECT]
[ZONE2 OFF]
[Front] [Rear]