Connecting an antenna
• Connect the FM antenna or AM loop antenna supplied with the unit |
to enjoy listening to radio broadcasts. |
nnAM loop antenna assembly
Basic
• After connecting the antenna and receiving a broadcast signal |
(vpage 17 “Listening to FM/AM broadcasts”), fix the antenna |
with tape in a position where the noise level becomes minimal. |
| Direction of broadcasting station |
AM loop antenna |
|
(supplied) | FM outdoor |
| antenna |
q w e | 75 Ω coaxial |
| |
| cable |
1 Put the stand section through the bottom of the loop antenna from the rear and bend it forward.
2 Insert the projecting part into the square hole in the stand.
Stand
Square
hole
Loop Projecting
antenna part
version
version Advanced
Black |
|
White | FM indoor |
| |
| antenna |
| (supplied) |
AM outdoor
antenna Ground
nnUsing the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Nail, tack, etc.
Standing alone
Use the procedure shown above to assemble.
NOTE
•Do not connect two FM antennas simultaneously.
•Even if an external AM antenna is used, do not disconnect the AM loop antenna.
•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
•If the signal has noise interference, connect the ground terminal (GND) to reduce noise.
•If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For details, inquire at the retail store where you purchased the unit.
Information
10