Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY
1 Turn off the power using ON/STANDBY.
2 Press ON/STANDBY while simultaneously pressing 8and 9.
3 Once the display starts flashing at intervals of about 1 second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Specifications
nn Audio section
• Power amplifier |
|
Rated output: | Front: |
| 75 W + 75 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.) |
| 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) |
| Center: |
| 75 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.) |
| 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) |
| Surround: |
| 75 W + 75 W (8 Ω, 20 Hz – 20 kHz with 0.08 % T.H.D.) |
| 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) |
Output connectors: | 6 – 16 Ω |
• Analog |
|
Input sensitivity/Input impedance: | 200 mV/47 kΩ |
Frequency response: | 10 Hz – 100 kHz — 0, |
S/N: | 98 dB |
nn Video section
• Standard video connectors |
|
Input/output level and impedance: | 1 |
Frequency response: | 5 Hz – 10 MHz — 0, |
nn Tuner section |
| [FM] | [AM] |
| (Note: μV at 75 Ω, 0 dBf = 1 x |
| |
Receiving Range: | 87.5 MHz – 108.0 MHz | 522 kHz – 1611 kHz | |
Usable Sensitivity: | 1.2 μV (12.8 dBf) | 18 μV | |
50 dB Quieting Sensitivity: | MONO | 2.8 μV (20.2 dBf) |
|
S/N | MONO | 70 dB |
|
| STEREO | 67 dB |
|
Total harmonic Distortion (at 1 kHz): | MONO | 0.7 % |
|
nn General | STEREO | 1.0 % |
|
|
|
| |
Power supply: | AC 230 V, 50/60 Hz |
| |
Power consumption: | 330 W |
|
|
| 0.5 W (Standby) |
| |
For purposes of improvement, specifications and design are subject to change without notice.
version Basic
version Advanced
Information
60