Denon AVR-1602 After starting playback, Dolby Digital, Dts, Pcm, Adjusting the sound quality tone

ENGLISH

3	Select the play mode.
	Press the SURROUND MODE button, then press the SELECT
	button.

		SURROUND
		MODE
	(Main unit)	(Remote control unit)
	To select the surround mode while adjusting
	the surround parameters, channel volume or
	tone control, press the surround mode
	button then operate the selector.
	(See page 29.)	(Main unit)
4	Start playback on the selected component.
	• For operating instructions, refer to the component’s
	manual.
5	Adjust the volume.	MASTER VOLUME

Input mode display

•In the AUTO mode

INPUT

AUTO PCMDTS

•In the DIGITAL PCM mode

INPUT

AUTO PCMDTS

•In the DIGITAL DTS mode

INPUT

AUTO PCMDTS

•In the ANALOG mode

INPUT

AUTO PCMDTS

Input signal display

•DOLBY DIGITAL

SIGNAL

DIGITAL

One of these lights, depending on the input signal.

DIGITAL ANALOG

DIGITAL

DIGITAL

ANALOG

		MASTER
		VOL
The volume level is	(Main unit)	(Remote control unit)
displayed on the
master volume level
display.

The volume can be adjusted within the range of –60 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 29, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”.

•DTS

SIGNAL

DIGITAL

•PCM

SIGNAL

DIGITAL

The DIGITAL indicator lights when digital signals are being input

properly. If the DIGITAL indicator does not light, check whether

the digital input component setup (page 20) and connections are

correct and whether the component’s power is turned on.

NOTE:

•The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard.

After starting playback

[1] Adjusting the sound quality (tone)

1	The tone switches as follows each time the TONE CONTROL
	button is pressed.
					B
		BASS	TREBLE
2		(Main unit)
	With the name of the volume to be				3	2	1
	adjusted selected, press the SELECT
	button to adjust the level.
	•	To increase the bass or treble: Press		3	If you do not want the bass and treble to be adjusted, turn on
		the SELECT UP button. (The bass or			the tone defeat mode.
		treble sound can be increased to up
		to +10 dB in steps of 2 dB.)			The signals do not pass through the
	•	To decrease the bass or treble: Press the SELECT DOWN
					bass and treble adjustment circuits,
		button. (The bass or treble sound can be decreased to up

to –10 dB in steps of 2 dB.) providing higher quality sound.

26