Denon AVR-682 D.Comp. Off, Default, English, Surround parameters w, LFE Low Frequency Effect

ENGLISH

6	Use the	(left) and	(right) buttons to set the D. COMP.
			(Initial)
			OFF	LOW	MID	HIGH
	(Remote control unit)	D.COMP. OFF
			(left) button		(right) button
	SURROUND

MENU

NOTE:

Press the SELECT or (down) button to switch to the LFE setting. This parameter is not displayed during DTS playback.

(Remote control unit)

7	Use the	(left) and	(right) buttons to set the LFE level.
			LFE	0dB
	(Remote control unit)

SURROUND

MENU

•The level can be adjusted in units of 1 dB from –10 to 0 dB.

(The level can be adjusted 1 dB at a time from 0 dB to +10 dB during DTS play.)

Set to the desired level according to the speaker systems being used and the source to be played.

Press the SELECT or (down) button to switch to the default setting.

(Remote control unit)

8	To reset the settings to the factory defaults, use the		(left) and	(right) buttons to display “Yes”.
	DEFAULT	Y/N		YES	NO
	(Remote control unit)		(left) button		(right) button

SURROUND

Press the SELECT or (down) button to switch to the D.COMP. setting.

MENU

(Remote control unit)

NOTE:

•When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the setting will be completed.

Surround parameters w

D.COMP. (Dynamic Range Compression):

Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four parameters (“OFF”, “LOW”, “MID” (middle) or “HI” (high)). Set to OFF for normal listening.

LFE (Low Frequency Effect):

Program source and adjustment range

1.Dolby Digital: –10 dB to 0 dB

2.DTS Surround: 0 dB to +10 dB

When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital playback.

When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback. When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.

33