Denon AVR-1708 sError Messages, Mic or, Ambient, Caution:Sp None, Caution:Phase, SBL

ENGLISH

Getting	Step 3 : Calculation
	When “Calculate” is selected at “Step 2”, the measurements taken are analyzed automatically
Started	to determine how the speaker system interacts with the room.
	Step 2 in 5 or less positions, press i to select “Calculate”.
Connections	“Calculate” is displayed when you have completed measurements in 6 positions. To complete
	The time required for this analysis depends on the number of speakers connected. The higher
	the number of speakers, the longer the time required for analysis.
	NOTE
Setup
	Do not change the speaker connections or subwoofer volume, or speaker locations after making
	measurements. These types of changes will invalidate the EQ solution provided. If changes
Playback	are necessary, make the changes and use the Audyssey MultEQ Auto Setup once again for an
	updated EQ solution.
Remote	Step 4 : Check
	Once the calculation is completed, a measuring result check (“Parameter Check”) is displayed.
Control	Press o to check the result.
	Press ui to select the item, then press o.
-Multi	Values that are different from the actual distance may be set for speakers with built-in filters
Zone	(subwoofers, etc). This is because filters add electrical delay to the signal that should be
	compensated.
Information
	Step 5 : Store
	The auto setup measurement results are stored in the AVR-1708 or cancelled.
Troubleshooting	After checking, press ENTER to select “Store”, then press ui to select “Store” or “Cancel”.
	Do not turn the power off while the settings are being stored.
	Store	: Press o to store this calibration permanently to memory.
	Cancel : Press o to cancel this calibration and clear all Auto Setup data measured.
	NOTE

sError Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc. an error message is displayed. Check the relevant items and be sure to take the necessary measures. After addressing any issues, perform the auto setup procedure over again.

Error messages (examples)			Cause					Measures
		• The included setup microphone is not					• Connect	the	included	setup
Mic or	Sp:NONE	connected.					microphone to <SETUP MIC>.
		• Not all speakers could be detected.					• Check the speaker connections.
		• Too much	noise in	the	room	for	• Either turn off any device generating
Ambient	Noise	accurate measurements to be made.					noise or move it away.
							• Try again when the surroundings are
							quiter.
		• Speaker or subwoofer sound is too					• Check the speaker installation and the
		low for accurate measurements to be					direction in which the speakers are
		made.					facing.
							• Adjust the subwoofer’s volume.
		• Displayed	speaker	could	not	be	• Check the	connections of		the
Caution:Sp None		detected.					displayed speaker.
		· The front L and front R speakers
FR		were not properly detected.
		· Only one channel of the surround
		speakers was detected.
		· Sound was output from the R
		channel when only one surround
		back speaker was connected.
		· The surround back speaker was
		detected, but the surrounds were
		not detected.
		• Displayed	speaker connected			with	• Check the polarities of the displayed
Caution:Phase		the polarities reversed.					speaker.
							• For some	speakers, this		error
SBL							message may be displayed even if
							the speaker is properly connected. If
							you are sure that the wiring is correct,
							select “Skip”.

Select “Retry” to make the measurements again.

NOTE Be sure to turn the power off before checking speaker connections.