ENGLISH |
|
| ||
Getting | <SOURCE SELECT> <SPEAKER B> |
| ||
<SPEAKER A> | ui | |||
Started |
|
|
| |
Connections |
|
|
| |
Setup | <POWER> | <QUICK SELECT> | <ENTER>, op | |
Playback | ||||
<ZONE2 / REC SELECT> |
| |||
|
| |||
Remote | [Front] |
|
| |
| [CH SELECT] | |||
Control |
| |||
uiop |
|
| ||
|
|
| ||
Information |
|
|
| |
Troubleshooting | [Rear] |
|
| |
uiop |
|
| ||
|
|
| ||
About the button names in these explanations
<> : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Other Operations and Functions
Other Operations
Recording on an External Device (REC OUT mode)
You can listen to one program source while recording a different program source.
1Press <ZONE2/REC SELECT> until “RECOUT” appears on the display.
ZONE2 
RECOUT
2Turn <SOURCE SELECT> to choose the input source to be recorded.
The “REC” indicator and the indicator for the selected source light.
RECOUT SOURCE 
RECOUT TUNER 
····
RECOUT XM
3Play the program source.
For operating instructions, refer to the respective equipment’s operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage 36).
4Start recording.
For operating instructions, refer to the respective equipment’s operating instructions.
•To cancel, press <ZONE2/REC SELECT>, then turn <SOURCE SELECT> until “ZONE2 SOURCE” is displayed.
•Make a test recording before starting the actual recording.
•Sources selected with the REC OUT mode are output from ZONE2 as well.
•In the REC OUT mode, the remote control unit’s ZONE2 mode buttons cannot be operated.
NOTE
•Recordings you make are for your personal enjoyment and should not be used for other purposes without permission of the copyright holder.
•Digital signals are not output from the REC OUT (CDR/TAPE and VCR) connector.
Convenient Functions
Channel Level
You can adjust the channel level either according to the playback sources or to suit your taste, as described below.
1Press <ENTER> or [CH SELECT].
FL Vol.+ 1.5dB
2Use ui, <ENTER> or [CH SELECT] to select the speaker.
The speaker that can be set switches each time one of the buttons is pressed.
3Use o p to adjust the volume.
b “OFF” can be set by pressing o when the subwoofer’s volume is set to
41