ENGLISH
Operating the remote control unit
Operating the remote control unit
[LEARNED/TX]
[POWER OFF] 
[ON/SOURCE]
[MODE SELECTOR] 
[MODE SELECT] 
Operating DENON audio components
1 Press [MODE SELECTOR] or [MODE SELECT] for the device to be operated.
• The button for the selected mode lights.
The mode switches as shown below each time [MODE SELECT] is pressed:
CD 
CDR/MD 
TAPE 
DVD/VDP
ZONE2 
TV 
DBS/CABLE 
VCR 
2 Operate the component.
For details, refer to the component’s operating instructions.
Setting the preset memory function
The various devices can be operated by setting the preset memory on the included remote control unit.
For some models the remote control unit or the device may not operate properly. In this case, use the learning function (
page 64) to store your device’s remote control signals in the included remote control unit.
•There may be several preset codes for some brands. If the remote control unit does not work properly with one code, try inputting another code.
•Buttons that have been learned have priority over the signals set with the preset memory function. If a learned button setting
is not needed, please erase it ( 
page 65).
NOTE:
•The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.
•It may not be possible to use some of the buttons, depending on the model and age of your equipment.
1 Press [ON/SOURCE] and [POWER OFF] at the
same time.
• The “LEARNED/TX” indicator blinks.
2 Press [MODE SELECTOR] for the device to be set in the preset memory.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
3 Input the
the list of preset codes ( 
End of this manual).
•When stored correctly, [MODE SELECTOR] and the “LEARNED/TX” indicator lights.
62
ENGLISH