After starting playback[1] Adjusting the sound quality (TONE)

•The tone control function will not work in the direct mode.

•The tone control setting only affects the front speakers.

•If the tone control function is used, the main volume cannot be adjusted up to 18 dB. (The maximum main volume level differs in the different surround modes.)

1

The tone switches as follows each time the TONE CONTROL

 

 

button is pressed.

 

 

BASSTREBLE

(Main unit)

With the name of the volume to be SELECT

2

adjusted selected, turn the SELECT

 

knob to adjust the level.

 

 

 

 

• To increase the bass or treble:

(Main unit)

 

 

 

Turn the control clockwise. (The bass or treble sound can

 

be increased to up to +10 dB in steps of 2 dB.)

•To decrease the bass or treble:

Turn the control clockwise. (The bass or treble sound can be decreased to up to –10 dB in steps of 2 dB.)

[2]Listening over headphones

1

Plug the

headphones’ plug into

PHONES

 

 

the jack.

 

 

 

 

 

 

 

 

 

Connect the

headphones

to

 

 

the PHONES jack.

 

 

 

The pre-out output (including

1

 

the

speaker

output)

is

automatically turned off when headphones are connected.

[3] Turning the sound off temporarily (MUTING)

1

Use this to turn off the audio output

 

 

temporarily.

 

Press the MUTING button.

Cancelling MUTING mode.

Press the MUTING button again or

 

2 3 1

3

If you do not want the bass and treble to be adjusted, turn on

the tone defeat mode.

 

 

The signals do not pass through the

 

bass and treble adjustment circuits,

 

providing higher quality sound.

1

NOTE:

To prevent hearing loss, do not raise the volume level excessively when using headphones.

1

adjust the main volume level.

(Remote control unit)

[4] Combining the currently playing sound with the desired image

1

Simulcast playback

 

FUNCTION

Use this switch to monitor a

 

video source other than the

 

 

audio source.

 

 

 

Press

the VIDEO

SELECT

 

 

button, turn the FUNCTION

 

 

knob

until the

desired

(Main unit)

 

source

appears

on the

 

display.

Cancelling simulcast playback.

•Select “SOURCE” using the VIDEO SELECT button and the FUNCTION knob.

•Switch the program source to the component connected to the video input.

1 1

1

Display

IN=V SOURCE

45