10
Easy Setup Procedure Easy Setup Procedure
Press <ON/STANDBY>or[ON].
•The power indicator blinks green and the power turns on.
Press <POWER>.
£OFF:
The power turns off and the indicator is off.
¢ON:
The power indicator lights red.
Turn on yoursubwoofer.
Set the volume to halfway and set the crossover frequency
to the maximum or Low pass filter off if your subwoofer can
adjust the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn
this function off before performing the Auto Setup
procedure.
Turn on yourmonitor.
wBefore performing the Auto Setup
procedure
1
2
3
4
ePerform the Auto Setup procedure
Press DDHHto select “Auto Setup / Room EQ”,
then press ENTER.
Press SYSTEM SETUP.
Press DDHHto select “Auto Setup”, then press
ENTER.
The message “Connect Microphone” is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
1
2
3
•“System Setup Menu” is not displayed when using
headphones.
1
2
3
rAssigning power amplifiers
Press DDHHto select “PowerAmp Assign”, then press
FFGGto set.
The surround back output can be assigned to the “Front” or
“ZONE2” output.
Front A, Front B:
Assign to use the “Front A” (or “Front B”) speakers with bi-
amp connections.
Surround Back:
Assign to use as surround back speaker.
When assigned to “Front”, skip the surround back channel
measurement.
During the auto setup procedure, test tones are not output
to “ZONE2”.
ZONE2:
Assign to use as “ZONE2” speakers.
tSwitching the front speaker
Press DDHHto select “Front Sp”, then press FFGGto
select the speaker.
Front A
Front A+B
Front B